Follow us :

  • The model number is on all packaging, some faucets, and all installation instructions provided with your kitchen sink faucet. On the packaging, look near the code or the top of the box. On the kitchen faucets and basin faucets, a model identification tag has been attached to most models manufactured since 2012. Look for the tag on one o...

  • Please keep in mind that all new faucets since 1994 are restricted to conserve water per EPA code mandates. Older faucets had no restrictions. Beyond intentional flow restriction, new installations can sometimes have reduced flow if the lines are not flushed prior to installation of aerators or shower heads. The flow restrictors require...

  • 1.To avoid dangerously hot temperatures, make sure your water heater is set at 120º F or below.2.Install a pressure balance tub and shower valve, such as those found in the broad selection of the Delta® Monitor® series.3.Set the valve’s adjustable rotational limit stop to prevent the temperature handle from being turned to dangerously h...

  • You need to push the fitting up over the nipple a little harder (you should hear a distinct "snap" or "click"). If you push it on gently, you might hear a slight click, but you haven't quite compressed the o-ring into the housing of the hose. One more push should solve the problem. And make sure your basin sink is clean enough. ...

  • With time and use, the set screw on a handle may loosen up. Using a hex wrench will allow you to retighten the set screw in the handle. Your kitchen faucet deck plate came with the correct hex wrench. If you can’t find the hex wrench that came with your faucet, most single handle kitchen faucets will use a 1/8th inch wrench, while most ...

  • With a pull down faucet, the spray wand is an extension of the faucet that you can literally pull down, whereas you need to pull out a pull out spray wand. A pull out wand can also be a part of the faucet or mounted separately on the sink ledge.

  • 4 signs you need to replace your kitchen sink faucet:1.There are visible mineral deposits. Mineral deposits can build-up inside your faucet, causing it to perform less than optimally.2.It's really, really old.3.It's gotten rusty. 4.It keeps leaking no matter how many times you try to fix it. ...

  • Depending on the design of your sink, it may have one, two or three holes, and they may appear between the faucet valves, facing toward you, or under the near rim, facing the mirror. They serve two functions: to prevent an overflow with the drain stopper engaged and to provide an escape route for air in the drain. ...

  • If the distance is six inches or more you need a “widespread" or “eight inch spread" faucet. If the measurement is less than six inches you need a “centerset," “mini-spread" or a “four inch spread faucet." Each of these configurations is for a brass bathroom sink faucet that will use all three holes in the sink. ...

  • The most common causes for sink faucets leaking include defective parts like o-rings, washers and gaskets. Corrosion and mineral depostis can also lead to sink faucets leaking. To troubleshoot widespread bathroom sink faucets dripping water, you will want to find the location of the water leak. ...

  • The OUBAO Lifetime Limited Warranty covers manufacturer defects in all OUBAO products for the length of time that the purchaser owns the original home where the OUBAO product is installed and/or used. Warranties are not transferable between homes or owners. Please refer to the Full Warranty for more information. ...

  • The 1992 Energy Policy Act directed manufacturers to restrict the amount of water released from faucets. In some instances, this flow was reduced from 5 GPM(gallons per minute) at 60 PSI(pounds per square inch) to 2.2 GPM at 60 PSI. Therefore, it is advised that you do not remove the flow restrictor from your faucet. All OUBAO faucet ex...

  • At OUBAO we guarantee that all bathroom faucets and kitchen faucets replacement parts are available for purchase for a period of 5 years. For further information please contact us at ..........com.

  • In order to eliminate stains and rust spots, use a non-abrasive or mild-abrasive cleaner. Remember that when applying force or using any abrasive cleaner to wash the modern kitchen faucets, you should always follow the direction of the grain on the surface. Do not scrub in the opposite direction, or against the grain, as you may scratch...

  • OUBAO Basin faucets easily be installed by you, we have instruction manual guide you to install the single basin faucet. However, if you still find it difficult to install. We recommend that you hire a certified plumber.

  • Some kitchen sink faucets that do not have a pull out sprayer may be connected to a portable dishwasher. Pull out faucets should never be connected to portable dishwashers because potential pressure fluctuations during washing cycles cause hose ruptures or leaks.

  • Turn off the basin faucet set water supplies.Disassemble and remove all internal faucet components.Place and hold an upside-down bucket over the faucet to deflect water into the sink.Carefully turn water supply on and let run one minute.Turn water supply off.Reassemble the faucet.Turn water supply on.

  • If you don’t want to modify your existing plumbing, you can get a standard shower, You can also get a OUBAO one handle shower faucet, which can give you that spa-like experience without requiring a major overhaul of your entire bathroom.

  • The most common reason is that there is something restricting the water flow to the single handle shower faucet spout (for example, solder or something lodged in the pipe). Something is impeding the flow of water to the spout and causing it to back up and go out of the shower head. If this is the cause of shower-rise, it is possible to remove the blockage by removing the tub spout, and then feedin...

  • Therefore you should design a configuration that will not exceed the amount of water the valve can provide, or that the hot water heater can support, or that and the drain can take away. It is best to work with an experienced designed and plumber when purchasing a custom single handle shower faucet.

  • 1,Install a pressure balance modern shower faucet, such as those found in the OUBAO shower faucet with handheld.2,Set the valve’s adjustable rotational limit stop to prevent the temperature handle from being turned to dangerously hot levels.3,Test the tub/shower water with your hand before bathing.

  • Follow the instructions in the installation manual supplied for your model when remove kitchen faucet seals.

  • Finishes are durable if cared for correctly – do not use abrasive and damaging cleansers. Overall chrome modern basin faucets is usually the most durable.

  • The way to fix that is to clean the gooseneck kitchen faucet spout. Then reinstall. This happens very often when homes have poor water quality. The hot and cold water is not filtered so anything could get inside there. Its mostly from wells NY, CA, FL or WA.

  • Simply remove one screw of the modern kitchen faucets little white battery box to open . The battery is clearly visible and can be replaced in a couple of seconds. The estimated battery life is half year.It depends on what kind of battery you're using.

  • The single handle shower faucet thermostatic core maintain the temperature at 38°C,avoiding water temperature getting too cold or too hot suddenly,eliminating scalding.

  • Remove and soak it in a 50/50 vinegar and water solution for several hours. The second most common cause is a kitchen sink faucets hose kinked under the sink. Check to be sure the hose doesn't kink when the sprayer is pulled out to be used. Third, the problem may be a blocked or damaged diverter assembly.

  • The hose for the kitchen faucet with pull down sprayer is flexible. Make sure it isn't caught on something underneath the sink.

  • There is no repair once the finish is damaged, however you can replace many of common kitchen water faucet where the finish deterioration is most noticeable.

  • Contact us the installation for your single hole kitchen faucet model when replacing the seals.

  • Between the pull-out hose and pull-out spray head there is a little filter screen in the kitchen faucet with sprayer, pushed into the pull-out hose connection fitting. Remove this using a sharp object, clean it and re-insert it.

  • The shower set wall mount hand shower should be installed so that it can be reached without any problem. You should be able to wash your hair while sitting on the tub without having to hold the hand shower.

  • If your pull kitchen faucet has a spout that is a high fill, cathedral or high arc spout there will be a collar that unscrews counterclockwise. When the collar has been loosened, pull up on the spout and remove it from the faucet. Many spouts will also feature a split white nylon washer to help secure the spout to the faucet.

  • All manufacturers must adhere to these standards and no adjustments can be made. In some cases, you may be receiving less than the maximum allowable water flow rate of the bathroom shower mixer set. Normally, this is due to low water pressure, a blockage in the plumbing or in the faucet, or a faucet malfunction.

  • Balancing the water flow keeps shower temperatures constant and comfortable, within ±3°F (1°C) of the original temperature, despite other demands such as flushing the toilet or starting the dishwasher. OUBAO's leaf series shower mixer shower set all feature pressure-balancing. Shower set mixer valves require pressure on the hot and the cold side to operate.

  • It is possible that the balancing spool of the shower mixer set is stuck due to non-use. Replace the shower system set cartridge to correct this situation. To prevent future issues, use the faucet at least once a week.

  • The single hole basin faucet finish cannot be repaired once damaged; however, you can replace many of common faucet parts where the finish deterioration is most noticeable.

  • Over time, this clear coat can be broken or scratched with regular wear and tear, abuse or chemical attack, causing the finish to tarnish or the coating to peel. Unfortunately, it's not possible to repair the clear coat so you will need to replace any kitchen faucet parts that are tarnished or badly scratched.

  • The pull down kitchen faucet Catalog section of our website will can let you to select a product, see what finishes are available for that product, and actually view the product in each of those finishes.

  • Qulity:Smooth pull down kitchen faucet parts movement offers precise control, allowing you to fine-tune temperature balance.Feature:Our kitchen sink pull down faucets are designed to be installed in a short period of time. Whether you are a plumber or a do-it-yourselfer, installation will be quick and easy.Style:Buy It For Looks.– OUBAO single handle pull down kitchen faucets are built for your li...